56
Ignition
Turn the gas bottle regulator to the open
position, so that the � ame symbol is facing
upwards.
Press the adjustment button and turn it
anticlockwise to the dot after the “PILOT”
position (see the arrow in the illustration).
Hold the adjustment button in for
approximately 30 seconds.
Continue to hold the adjustment button and
press the IGNITER button repeatedly until the
pilot comes on.
Once the pilot is lit, hold the adjustment
button for a further 30 seconds.
You can see the pilot through the small
window at the bottom of the burner (next
to the control panel).
Then turn the adjustment button to HI
(maximum heat output) so that the pilot
lights the burner, and allow the patio heater
to heat up for 5 minutes.
Once the patio heater has warmed up, turn
the adjustment button to the required heat
setting between HI (maximum) and LO
(minimum).
If the pilot will not come on, try again
or follow the instructions under
Troubleshooting.
Note!
On � rst use or after changing the gas bottle,
turn the adjustment button to the dot after
the PILOT position and hold it in for 3-4
minutes before trying to ignite the patio
heater. This is because the gas will have to
press the air out of the pipe system before
the pilot can be lit.
Always remember to hold the adjustment
button in when pressing the igniter button.
Switching off
Turn the adjustment button to the PILOT
position.
Press the adjustment button in and turn it
to the OFF position.
Turn the gas bottle regulator to the closed
position, so that the � ame symbol is facing
downwards.
Turn the adjustment
button to this and hold it
in for at least 30 seconds
before pressing the
igniter button.
