HP Enterprise FlexNetwork 10500 Series, Configuration Manual

Page: 63 / 325

54
Tasks at a glance
(Required.) Perform one of the following tasks:
•
Disabling authentication for Telnet login
•
Configuring password authentication for Telnet login
•
Configuring scheme authentication for Telnet login
(Optional.) Setting the maximum number of concurrent Telnet users
(Optional.) Setting the DSCP value for outgoing Telnet packets
(Optional.) Specifying the Telnet service port number
(Optional.) Configuring common VTY line settings
Telnet login configuration changes do not take effect for current online users. They take effect only
for new login users.
Enabling Telnet server
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enable the Telnet server.
telnet server enable By default, the Telnet server is disabled.
Disabling authentication for Telnet login
Step Command Remarks
1. Enter system view.
system-view N/A
2. Enter VTY line view or
class view.
•
Enter VTY line view:
line vty first - number
[ last-number ]
•
Enter VTY line class
view:
line class vty
A setting in user line view applies only to
the user line. A setting in user line class
view applies to all user lines of the class.
A non-default setting in either view takes
precedence over a default setting in the
other view. A non-default setting in user
line view takes precedence over a
non-default setting in user line class view.
A setting in user line class view does not
take effect for current online users. It takes
effect only for new login users.
3. Disable authentication.
authentication-mode none
In non-FIPS mode, password
authentication is enabled for VTY lines by
default.
In VTY line view, this command is
associated with the
protocol inbound
command. If you specify a non-default
value for one of the two commands, the
other command uses the default setting,
regardless of the setting in VTY line class
view.
4. (Optional.) Assign a user
role.
user-role
role-name
By default, a VTY line user of the default
MDC is assigned the
network-operator
user role. A VTY line user of a non-default
MDC is assigned the
mdc-operator user
role.
After you finish this configuration task, a user can Telnet to the device without authentication, as
shown in the following example: