55
******************************************************************************
* Copyright (c) 2010-2017 Hewlett Packard Enterprise Development LP *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
******************************************************************************
<HPE>
If the maximum number of login users has been reached, the login attempt fails and the message "All
user lines are used, please try later!" appears.
Configuring password authentication for Telnet login
Step
Command
Remarks
1.
Enter system view.
system-view
N/A
2.
Enter VTY line view
or class view.
•
Enter VTY line view:
line vty
first
-
number
[
last-number
]
•
Enter VTY line class view:
line class vty
A setting in user line view applies only
to the user line. A setting in user line
class view applies to all user lines of
the class.
A non-default setting in either view
takes precedence over a default
setting in the other view. A non-default
setting in user line view takes
precedence over a non-default setting
in user line class view.
A setting in user line class view does
not take effect for current online users.
It takes effect only for new login users.
3.
Enable password
authentication.
authentication-mode password
In non-FIPS mode, password
authentication is enabled for VTY lines
by default.
In VTY line view, this command is
associated with the
protocol inbound
command. If you specify a non-default
value for one of the two commands,
the other command uses the default
setting, regardless of the setting in
VTY line class view.
4.
Set a password.
set authentication password
{
hash
|
simple
}
password
By default, no password is set.
5.
(Optional.) Assign a
user role.
user-role
role-name
By default, a VTY line user of the
default MDC is assigned the
network-operator
user role. A VTY
line user of a non-default MDC is
assigned the
mdc-operator
user role.
After you finish this configuration task, a user must provide the configured password when Telnetting
to the device, as shown in the following example:
******************************************************************************
* Copyright (c) 2010-2017 Hewlett Packard Enterprise Development LP *
* Without the owner's prior written consent, *
* no decompiling or reverse-engineering shall be allowed. *
******************************************************************************
Summary of Contents for FlexNetwork 10500 Series
Page 139: ...130 Sysname display version ...
