４
Power switch
５
Prior to using a new tip, perform tinning
(applying solder to the tip). Put solder to the
tip and wait until solder melts.
Tinning is finished by that the surface is well
covered.
Preparation
If solder balls up and does not stick to the tip, this is too hot or an oxidation film has
soiled the surface. Clean the tip, allow to cool, and begin again.
The tip surface is apt to be oxidized if the iron is heated without load. Set less than
300
℃
. Previously put solder against the area to be soldered and wait until melts.
●
●
Caution
４
Be sure that the power switch is turned off, then
connect the power plug to the wall outlet.
３
Connect the plug of the iron to the receptacle of the
station.
The contact pins are fixed as the illustration. Engage
the projection at the zenith with the zenith of the
receptacle.
Always ground when use. This is important to prevent operator’s electric shock and to
protect the temperature control circuit from outer noises.
Caution
