19.05
Bring the tip of the HC-31 close to the magnetized object. While pushing the pow-
er switch, gradually pull the HC-31 away from the object approximately 30cm, and
release the switch.
●
For other
object
Operation
４
Bring the tip of the HC-31 close to the
area where color distortion was occurred
on the cathode ray tube. While pushing
the power switch, gradually pull the HC-31
away from the screen, and release the
switch when the distortion stops.
Repeat the operation or orient the HC-31
parallel with the tube face.
２
１
Plug in the power plug to the wall outlet.
●
For cathode ray tube
The same procedure as TV tube.
If your PC monitor is by aperture-mask system,
after finishing this procedure, sometimes verti-
cal lines appear on the screen by distortion on
aperture-musk itself receiving repercussion of
the demagnetizer, but this is not malfunction. In
case of this, softly hit the side of the monitor set
to recover.
Caution
1-2-12 Saiwaicho, Naniwa-ku, Osaka 556-0021, Japan
Tel : +81-6-6567-3111
Fa x : +81-6-6562-0024
