20
To enter the set-up mode, press the OK button on the display for 10 seconds
until two blinking horizontal lines appear on the display. Then long-press the
FuV button on the control unit until the orange indicator light is blinking fast.
After entering the set-up mode, select the
Std
,
Uni
or
tESt
program using
the arrows and confirm with the OK button.
STD PROGRAM
It is not possible to extend or shorten the phase of active burning in the
Std
program. The starting temperature
T
start
it set to 250°C. Continue to step 5.
UNI PROGRAM
The
Uni
program is designed for individual builds of fire chambers or to
shorten / extend the active burning phase.
Select the starting temperature
T
start
80°C (
t 80
) or 250°C (
t250
) and press
OK to confirm. Choosing the starting temperature depends on the location
of the temperature sensor. It is necessary that the
T
start
(80°C or 250°C) is
always reached during the operation.
SET-UP
1
2
3
4.1
4.1
SETTING UP THE PRODUCT AND THE COMMUNICATION CHANNEL
To access the display batteries, press the bottom of
white back cover in the middle and tilt it to the back
(see figure) Remove the strip between the battery and
the contact and close the cover.
ABRA 6.1 is ready for use right after unpacking and
plugging it in. The communication channel
Ch-1
and program
Std
are set by default. The
Std
mode
is suitable for all Hoxter fireplace inserts when the
temperature sensor is installed in the designed
position on the insert.
