8
●
Push the plenum mounting bracket upward to snap into
the square hole
.
●
Tighten M8 bolt to make sure the plenum mounting
bracket is connected with outdoor unit tightly
.
●
It
’
s suggested that when screwing the bolt
,
torque
should be 7N
.
M which could make the connection
between outdoor unit and outlet gasket perfect
.
●
Check if the plenum mounting bracket is completely
embedded into the square hole
.
3 Pole terminal block
Install plenum mounting bracket
●
Overlap M8 bolt with washer and fixing metal
plates
,
and get bolts through the 4 holes on corners of
the plenum mounting bracket
.
●
Make sure fixing metal plates is 10mm distance from
the plenum mounting bracket in order to adjust angle
during installation
.
Note
Match the corresponding active
,
neutral and the
ground wire and firmly tighten up the screws to
make sure the power line is not loose or
improperly connected
,
otherwise a short circuit
or fire could be caused
.
Connect outlet air duct
●
Snap the outlet air duct into the square hole on the
plenum mounting bracket
,
Four
fixed
hole
position
is
naturally
aligned
.
●
Screw the
outlet air duct with the plenum
mounting
bracket with 4 flat head screws from underneath the
plenum mounting bracket,support the square duct ring
by hand when screwing.
Fixed hole
Square duct ring
Truss head screw