Page 26
NOTE:
A defoamer may be needed to decrease the amount of foam
caused by the anti-freeze.
4. Drain your spa to ensure removal of anti-freeze. Do not drain water
on grass or plants due to excessive chlorine level.
5. After the spa has completely drained, re-install your filter and follow
the Start-up and Refill Procedures in the Operating Instructions
section of the Owner’s Manual.
IMPORTANT:
Always keep spa covered when not in use, whether it is
empty or full.
FILTER SYSTEM
HOT SPRING
spas are equipped with one filter cartridge, sized to meet
the needs of the jet pump system.
At least once a week, check and clean the skimmer basket and weir to
ensure proper filter flow. Remove leaves, foreign matter, and debris. It is
very important to keep your spa filter cartridge clean and free of particles
to ensure proper water flow. A clean filter permits the hydrotherapy
system to function properly and also allows more efficient filter cycles.
Depending on how frequently your spa is used, we recommend cleaning
the spa filter cartridge every four weeks. If this is not done, the filter may
clog and restrict water flow, which causes improper filtration and poor jet
performance.
WARNING:
To reduce the risk of injury to persons using the spa,
DO NOT remove the suction fittings (filter standpipes) located in the filter
compartment and do not sit on the filter cover.
SECONDARY SUCTION SCREEN
Located in the foot well of your spa are secondary suction screens.
The screen is used as a filter to prevent dirt from circulating through the
system.
WARNING:
Do not use the spa with the suction screens removed.
FILTER CARTRIDGES
REMOVAL & CLEANING
1. Disconnect the spa from the power supply by turning the power to the
spa OFF.
2. Remove
any floating
items from
within the filter
compartment.
3. Turn the filter
retainer handle
(located on
the top of the
filter cartridge)
counterclockwise
until the retainer
can be removed
from the filter
standpipe.
4. Remove the
filter retainer,
cover and
cartridge
SERVICE NOTE:
Never remove the filter standpipe when debris is present
in the filter compartment. Debris may find its way into the internal plumbing
which may result in blockage. NEVER REMOVE SUCTION FITTINGS!
5. Always clean the filter using a filter degreaser, such as
HOT
SPRING
FRESHWATER
Filter Cleaner, to remove mineral and
oil build-up. Simply soak the filter in the degreaser according to the
package directions, then place the filter on a clean surface and spray
until clean using a garden hose. It may be necessary to rotate the
filter while spraying to remove any debris lodged between the filter
pleats.
6. To reinstall the filter cartridge, reverse the order of steps in which it
was removed. Do not overtighten.
WARNING:
Do not use the spa with the filter cartridges, or filter
standpipe(s) removed!
CARE OF THE SPA PILLOWS
The spa pillows will provide years of comfort if treated with care. They
have been positioned above the water level to minimize the bleaching
effects of chlorinated water, and other spa water chemicals. To extend
their life, whenever the spa shell is being cleaned, the spa pillows
should be removed and cleaned. Body oils can be removed with a mild
soap and water solution. ALWAYS rinse off the spa pillows thoroughly
to remove any soap residue. The pillows can be conditioned with
HOT
SPRING
Cover Shield after cleaning. If the spa is not going to be
used for a long period of time (that is during a vacation, or if the spa is
winterized), or when the spa water is being super-chlorinated, the spa
pillows should be removed until the next spa use.
To remove and replace the spa pillows:
1. Carefully lift one end of the pillow away from the spa shell.
2. Continue lifting one end until all pillow retainers are released from the
pillow.
IMPORTANT
: Just pulling the pillow straight up and out of the shell
recess will eventually damage the pillow. This abuse is not covered
under warranty.
3. To reinstall the spa pillow, carefully bend the pillow slightly to allow
one of the pillow retainers to slip into the recess in the back of the
pillow.
4. Keeping the pillow slightly bent, slide the other pillow retainer into the
recess in the back of the pillow.
5. After all the pillow retainers are in place, press the pillow down into
the recess in the spa shell.
CARE OF THE EXTERIOR
SPA SHELL
Your
HOT SPRING
spa has an acrylic shell. Stains and dirt generally will
not adhere to your spa’s surface. A soft rag or a nylon scrubber should
easily remove most dirt. Most household chemicals are harmful to your
spa’s shell (see below for detailed information on cleaning agents).
Always rinse off any spa shell cleaning agent with fresh water.
IMPORTANT:
1. The following products are the ONLY approved cleaning agents
for your
HOT SPRING
spa shell: plain water,
HOT SPRING
FRESHWATER
Spa Shine, or Soft Scrub
®
. The use of alcohol or any
other household cleaner other than those listed to clean the spa shell
surface is NOT recommended. DO NOT use any cleaning products
containing abrasives or solvents since they may damage the shell
surface, specifically: Simple Green
®
, Windex
®
or Spa Mitt. NEVER
USE HARSH CHEMICALS! Damage to the shell by use of harsh
chemicals is not covered under the warranty. Always rinse off any
spa shell cleaning agent with fresh water.
FILTER
CARTRIDGE
STANDPIPE
RETAINER
HANDLE
FRESHWATER
Ag+
SILVER ION
PURIFIER INSIDE
STANDPIPE
FILTER
COVER
Spa Care and Maintenance
