Page 14
Page 14
COMBINATION XL HYDROMASSAGE JETS
These large jets may be adjusted to provide either a stationary, direct stream, or, by positioning the nozzle to one side, a
variety of rotating massage patterns. Also, the speed of the rotation can be changed by rotating the jet faceplate from a
full stream, to shutting the jet completely off. To avoid damage to your spa’s plumbing and components, do not turn off
more than half of these jets at the same time.
COMBINATION JETS MAINTENANCE
If you notice that either the Combination or Combination XL jets spin slower than when the spa was new, or the jets are sticking, the cause may be
built-up deposits inside the jet bearings. To remove the deposits, use the following instructions:
1. With the spa off, rotate the combination jet face counter-clockwise until it stops.
2. Once the face stops rotating, push in and use a little extra force to rotate the face even more counter-clockwise past the locking position until
it stops. Pull face with the body away from the spa.
3. After flushing the bearing inside the body with water, spin the rotating eye, it should spin very freely. If it does not, place the bearing end in a
cup of vinegar (the vinegar will soften any deposits). Leave soaking overnight. The next day, flush with water and repeat the spin test.
NOTE
: If it still doesn’t spin freely, a second night of soaking is required. If the bearing still does not spin, you will need to purchase a
replacement assembly from your Limelight
TM
dealer.
4. To replace, position the cutout at the back end of the face body downward and push the face body back into the spa fitting. Slightly rotate
face body in either direction until you feel the body align with the fitting, then press firmly on the face body. Once seated, push and rotate the
face clockwise using a little extra force to overcome the locking position. If the face does not rotate, remove and rotate face body 180° and
repeat this step. Turn the jet pump on, the combination jet should spin freely.
WATER FEATURE
The Limelight Pulse
TM
, Flair
TM
, and Glow
™
hot tubs come equipped with a Vidro
™
water feature. This water feature can be turned on or off when the
two-speed pump is on low speed (tranquil mode) or high speed. To function correctly, the water feature on/off lever must be placed in the ffuullll oonn
position only.
If the lever is not in the ffuullll oonn position when the pump is on high speed, it is likely that the water feature will project water substantially farther out
into the hot tub as the on/off lever is opened. This is not proper operation. If this occurs, the pump should be turned off, the water feature lever
rotated to the full on position and the pump turned on again.
CAUTION:
Partial blockage of water flow at entrance of water feature will cause the water to flow farther into or over the hot tub.
Operating Instructions
Summary of Contents for FLR
Page 1: ...Page 1 O w n e r s M a n u a l by...
Page 43: ...Page 40 Page 40 NOTES...
