Copyright 2013 HotSpot Energy
Connecting To The Indoor Unit
NOTE:
Before performing any electrical work, turn off the main power to the system AND MAKE SURE ALL
CAPACITORS ARE DISCHARGED.
1. The (5) five inside connecting cables can be connected without removing the front grille.
2. The 5 connecting power cable s must be sized correctly, see page 11.
3. Lift the indoor unit panel up, remove the electrical box cover by loosening the screw.
4. Ensure the color code of the indoor unit wire terminals match the outdoor unit terminal numbers and the
wiring diagram.
5. Wrap any cables not connected with terminals with insulation tape so that they will not touch any
electrical components. Secure the cable onto the control board with the cable clamp.
Figure 12
Figure 11
If using an installation bracket, the installation bracket should be installed according to the installation
bracket diagram. The installation wall should be solid brick, concrete or similar level of construction, or
actions to reinforce the supporting bracket should be taken. The connection between the bracket and wall,
and the bracket and the air conditioner should be firm, stable and reliable. Be sure there are no obstacles
which can block the flow of air.
Figure 13
12
OUTDOOR INSTALLATION PRECAUTION
Install the outdoor unit on a rigid base to prevent excess noise and
vibration.
Determine the air inlet and outlet direction, be sure that the flow of
air is not blocked.
In the case that the installation site is exposed to strong winds such as
the ocean front, make sure the fan can operate properly by putting
the unit lengthwise along the wall or using a dust or wind shield. See
figure 13.
