28 of 33
Service Manual UK
Indesit
Company
English
DISMANTLING INSTRUCTIONS
SAFETY NOTES
1.
Ensure that the appliance is disconnected from the electrical supply before dismantling.
2.
Beware of sharp edges on metal panels, plastic mouldings, and pressed parts.
3.
Some fixings (especially those into plastic) must be tightened to the correct specification
using a suitable torque wrench.
4.
Insulation resistance tests must be carried out with the pressure switch set to ensure that
the water heater is 'in-circuit' during the test.
A
Table Top
1.
Remove the two screws at the top rear of cabinet.
2.
Slide the table top backwards to disengage the location fixings at the rear and lift off.
B
Rear Access Panel
1.
Remove 6 screws from the rear access panel.
2.
Slide panel down and lift clear.
C
Dispenser Drawer
1.
Open the dispenser drawer fully.
Gently lift slightly and pull. See right.
D
Console Panel
1.
Remove the table top (A).
2.
Remove the dispenser drawer (C).
3.
Remove two top screws securing the panel to the cabinet and two screws securing the panel to the
dispenser.
4.
Unplug the wiring from the cabinet side to the console PCB - taking note of position.
5.
Remove two screws from the valve support plate and move the dispenser to the rear.
6.
Unclip two plastic lugs securing the console panel to the front panel and lift clear.
7.
Avoid unclipping and handling the control board unless absolutely necessary, as the control board
is susceptible to static electricity.
