Hotpoint WD420, Instruction Booklet

Page: 4 / 16

! When the machine is installed, the mains socket
must be within easy reach and should be connected
to a suitable electrical supply.
! Do not use extensions or multiple sockets.
! The power supply cable must never be bent or
dangerously compressed.
! The power supply cable must only be replaced by
an authorised serviceman.
! The company denies all liability if and when these
norms are not respected.
Models WD440,
WD420
59.5cm wide
Dimensions 85cm high
60cm deep
Capacity from 1 to 6kg Wash
from 1 to 5kg Dry
Electric voltage 220/230 Volts 50Hz
connections maximum absorbed power 1700W
Water maximum pressure 1 MPa (10 bar)
connections minimum pressure 0.05 MPa (0.5 bar)
Spin Speed up to 1400 rpm - WD440
up to 1200 rpm - WD420
Control programme D
programmes temperature 60˚C
according to
IEC456
- Wash run with a 6kg load
directive - Dry run with 5kg & 1kg loads
This appliance is compliant with the
following European Community
Directives:
- 72/23/EEC & 93/68/EEC
(Low Voltage) and subsequent amendments.
- 89/336/EEC,92/31/EEC & 93/68/EEC
(Electromagnetic Compatibility) and subsequent
amendments.
The first wash cycle
Once the appliance has been installed and before you
use it for the first time, run a wash cycle without
detergent and no laundry, setting the 95˚C
programme B without a pre-wash cycle. This will take
approximately 2 hours 30 minutes to complete.
Drainage connections
We recommend one of the following:
! Although you may need to move the hooked end
support along the grey drainage hose, DO NOT
remove it.
! Whichever drainage method you use, make sure that
the hooked end support is fixed level to, or above the
‘Plumbing Indicator Line’ (
see Description ).
Standpipe method:
1. Make sure the standpipe
height is a minimum 500mm from
the floor.
2. Insert the drainage hose
approximately 100mm into the
standpipe.
Under sink method:
1. Cut off the blocked end of the
under sink drainage unit.
2. Fix the hooked end support a
minimum of 800mm from the
floor.
3. Use a hose clip to securely
attach the grey drainage hose
end to the under sink drainage
unit using a hose.
Electrical connections
Before plugging the appliance into the mains socket,
make sure that:
●
the socket is earthed and in compliance with the
applicable law.
●
the socket is able to sustain the appliances
maximum power load indicated in the Technical
Details table (
on the right ).
●
the supply voltage is included within the values
indicated in the Technical Details table (
on the right ).
●
the socket is compatible with the machines plug.
If this is not the case, replace the socket or the
plug.
! The machine should not be installed in an outdoor
environment, not even when the area is sheltered,
because it may be very dangerous to leave it exposed
to rain and thunderstorms.
3
Technical Details
Hooked end
support
Hose clip
minimum:
500mm
minimum:
800mm
from floor
GB
Installation