Cleaning the door bowl
Clean the internal surface of the door bowl regularly
with a soft cloth. A build up of soap powder and water
hardness residue may result in water leaking from the
door.
●
Always leave the appliance door ajar to prevent
unpleasant odours from forming.
Checking the water inlet hoses
Check the water fill hoses at least once a year. If you
see any cracks, replace them immediately:
during the wash cycles, high water pressure could
cause a cracked hose to split open.
!
Never use hoses that have already been used.
Care and maintenance
Switching off the electricity
●
Turn off the water tap after every wash. This will
limit the wear of your appliances water system
and also prevent leaks.
●
Unplug your appliance when cleaning it and
during all maintenance operations.
Cleaning
Cleaning the exterior
Use a damp cloth or silicon polish to clean the exterior
surfaces of the appliance.
Cleaning the dispenser drawer and compartments
It is advisable to clean the dispenser drawer regularly.
!
Do not try to clean any part of the dispenser drawer
while the machine is running.
1. Pull out the drawer until it reaches its stop.
2. Press the drawer release
button to remove the dispenser
drawer (
see pic
)
.
3. Clean and dry the dispenser
drawer, syphons, grate and
fabric conditioner exit channel
(
A
). Also regularly clean the
outlet pipe area (
B
).
4. Relocate the dispenser drawer and push it firmly
back into place.
!
Do not clean any part of the machine with abrasive
cleaners, scouring agents, acids, any bleach or metal
polish as they may cause damage.
!
We recommend a maintenance wash 2 or 3 times a
year, to avoid a build up of greasy deposits and
water hardness residue. Run Programme B, without
laundry and without detergent.
●
Where the drying only option is regularly used, do
this on a monthly basis.
A
B
12
Moulded plug
!
The plug must not be used
without the fuse cover in place.
If a replacement fuse
holder/cover is required, it must
be of the same colour coding or
wording as shown on the base
of the plug.
Replacements are available
from authorised dealers.
Changing the plug
The wires in the power cord are coloured in accordance
with the following:
!
If the plug being replaced is a non-rewirable type,
then the cut-off plug must be disposed of safely.
DO NOT leave it where it can be inserted into a socket
and create a shock hazard.
!
The power supply cord should be checked periodically
and replaced by a cord specially prepared for this
machine and fitted only by authorised technicians (
see
Service
). New or longer power cords are supplied at
an extra charge by authorised dealers.
!
The manufacturer denies any responsibility should
any of these rules not be followed.
!
If in doubt about any of the above consult a
qualified electrician.
Green and Yellow
(Earth) wire to terminal
marked ‘E’, symbol ,
or coloured green and
yellow.
13A ASTA approved
fuse to BS1362.
Brown (Live) wire to
terminal marked ‘L’ or
coloured red.
Blue (Neutral) wire to
terminal marked ‘N’ or
coloured black.
Cord clamp
Installation
Description
Star
ting and
Pr
ogrammes
Deter
g
ent and
Laundr
y
Precautions and
ad
vice
Care and
Maintenance
T
roub
leshooting
Ser
vice
GB
Summary of Contents for WD420
Page 1: ...Instructions WD440 WD420 ...
