GB
17
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
Inspecting the seals
Check the door seals around the oven regularly. If the seals
are damaged, please contact your nearest Service Centre
(see Assistance). We recommend that the oven is not used
until the seals have been replaced.
Replacing the light bulb
To replace the oven light
bulb:
1. Remove the glass cover
of the lamp-holder.
2. Remove the light bulb and
replace it with a similar one:
halogen lamp voltage 230 V,
wattage 25 W, cap G 9.
3. Replace the glass cover
(see diagram).
!
Do not touch the light bulb directly with your hands.
!
Do not use the oven lamp as/for ambient lighting.
Sliding rack kit assembly
To assemble the sliding
racks:
1. Remove the two frames,
lifting them away from the
spacers A (see figure).
2. Choose which shelf to use
with the sliding rack. Paying
attention to the direction in
which the sliding rack is to
be extracted, position joint B
and then joint C on the
frame.
3. Secure the two frames
with the guide rails using the
holes provided on the oven
walls (see diagram). The
holes for the left frame are
situated at the top, while the
holes for the right frame are
at the bottom.
4. Finally, fit the frames on
the spacers A.
!
Do not place the sliding racks in position 5.
Glass cover
Lamp
Lamp
Holder
compartment
A
B
C
Left
guide rail
Right guide
rail
Direction
of extraction
D
Automatic cleaning by PYROLYSIS
The cleaning cycle can cause the internal temperature of
the oven to reach 500°C. The pyrolytic cycle is activated,
burning away food and grime residues. Dirt is literally
incinerated.
Keep children away from the appliance during the automatic
cleaning cycle as surfaces may become very hot. Particles
may ignite inside the oven as a result of the combustion
process. There is no cause for concern: this process is both
normal and hazard-free.
Before initiating the PYROLYTIC cycle:
• clean the oven door;
• remove large or coarse food residues from the inside of
the oven using a damp sponge. Do not use detergents;
• remove all accessories and the sliding rack kit (where
present);
• do not place tea towels or pot holders over the oven
handle.
!
If the oven is too hot, the pyrolytic cycle may not start.
Wait for the oven to cool down.
!
The programme may only be started once the oven door
has been closed.
To activate the cleaning cycle
:
1. Press
to switch on the control panel.
2. Press the
icon.
3. Scroll through the menu commands using the control
dial, select PYROLYTIC and press
.
4. The appliance suggests a “NORMAL” pyrolytic cycle, with
a duration of 1 hour 30 minutes. Other levels of cleaning
may be selected.
• Use the control dial to select one of the following:
-
“ECONOMY”: duration 1 hour
-
“NORMAL”: duration 1 hour and 30 minutes
-
“INTENSIVE”: duration 2 hours.
•
Press
again.
5. Press
to begin the PYROLYTIC cycle.
Safety devices
• The door locks automatically as soon as the temperature
reaches a high value; the icon lights up on the display.
• Pressing the
icon cancels the cleaning cycle at any
time.
• If a malfunction occurs, the heating elements will be
switched off.
• Once the oven door has been locked, you cannot change
the duration and end time settings.
Programming delayed automatic cleaning
!
Programming is possible only after selecting the cleaning
cycle.
1. Press the
icon twice; the end of pyrolysis time will
begin to flash.
2. Turn the control dial to adjust the end of pyrolysis time;
hold the dial in this position to scroll through the numbers
