34 of 39
Service Manual UK
Indesit
Company
English
PROGRAMMING (Using Smartcard Reader / Card).
If the Main Module has been replaced during a repair the module will require programming using the
following method.
1.
Do NOT connect the machine to electrical supply
.
2.
Insert the pre-programmed card into the Card reader.
Care must be taken at this point to ensure the card is
inserted correctly with the Chip on the card facing the
PCB of the Reader.
3.
Insert the Reader & Card into module connection port
- see photo. You MUST hold the Reader in place
whilst programming is taking place.
4.
Connect the machine to the Electrical supply
, the
LED's on the Smart Card Reader will light in this
sequence:
a)
Red OFF: Good Communication between Smart Card
Reader & Card.
b)
Red OFF; Green Blinking: Download taking place.
c)
At end, Green ON ---> Download OK.
d)
At end, Red ON ---> Download NOT OK.
5. Programming Complete, disconnect the machine from
Electrical supply.
6. Remove the Smart Card Reader.
Smart Card Reader
and Smart Card in use
You MUST hold the Reader in place whilst
programming is taking place.
It does not stay in position on its own.
Smart
Smart Card
this card holds
the program file
and can ONLY
be used ONCE.
Card
After the module
has been programmed
the card is automatically
erased.
Reader
