30 of 39
Service Manual UK
Indesit
Company
English
P.
Display Board
1.
Remove outer door panel C).
2.
Remove console panel (6 screws) and disconnect wiring plugs (2). Note the connector orientation and
position. Carefully ease the ribbon cable (connected to the touch control surface) from its socket.
The touch control surface is an integral part of the console moulding and is not available separately.
3.
Remove the door switch (2 screws).
4.
Unclip the handle housing. Ensure correct position of the outer lip during reassembly. See Fig. 3.
5.
Using a flat bladed screw driver, carefully ease 8 clips securing display card cradle to console panel
(see Fig. 2 below), and remove the board assembly.
Fig.1
Console panel
Display / Control Board assembly
Door Switch
Handle Housing
Ribbon Cable
screw
screw
Release clips (8)
Fig.3
Handle Housing
correct lip location
viewed from user side
Front edge
Rear edge
