GB
27
PLEASE PHONE US TO REGISTER YOUR APPLIANCE AND ACTIVATE YOUR PARTS GUARANTEE ON 08448 24 24 24
If something
goes wrong...
Problem
Check
Oven light does
not work
The oven lamp is not covered by the guarantee. The part is easily changed (see the sec-
tion on oven lamp replacement). A new lamp may be obtained from our Parts department
see back page.
Draught from
beneath control
panel
A gentle flow of air will be blown from beneath the control panel when the appliance is
used. If the appliance is still warm, this cooling fan may run on, or restart itself when all
controls have been turned off. The fan will stop once the appliance has been cooled. This
is normal and not a fault.
Steam / Conden-
sation in the oven
after use.
Steam is a by - product of cooking any food with a high water content. To help minimise
always:
a) Try to avoid leaving food in the oven to cool after being cooked.
b) Use a covered container, wherever possible.
If you have been through the above list and there is still a problem, contact Service (see back page).
Disposal of your product
To minimise the risk of injury to children please dispose of
your product carefully and safely. Remove all doors and
lids. Remove the mains cable (where fitted) by cutting
off flush with the appliance and always ensure that no
plug is left in a condition where it could be connected to
the electricity supply.
To help the environment, Local Authority instructions
should be followed for the disposal of your product.
Disposal of old electrical appliances
The European Directive 2002/96/EC on Waste Electrical
and Electronic Equipment (WEEE), requires that old
household electrical appliances must not be disposed
of in the normal unsorted municipal waste stream. Old
appliances must be collected separately in order to
optimise the recovery and recycling of the materials
they contain and reduce the impact on human health
and the environment.
The crossed out „wheeled bin” symbol on the product
reminds you of your obligation, that when you dispose of
the appliance it must be separately collected.
Consumers should contact their local authority or retailer
for information concerning the correct disposal of their
old appliance.
Problem
Possible cause
Solution
The appliance has just been
connected to the electricity
mains or there has been a blackou
Set the clock.
A programmed cooking mode
does not start.
There has been a blackout.
Reprogram the cooking mode.
Only the high luminosity
“Clock button” is lit.
The appliance is in standby mode Press any button to exit
standby mode.
An automatic mode has been
selected. “Hot” appears on the
display and cooking does not start
The temperature inside the oven
is higher than the suggested value
for the selected mode.
Wait for the oven to cool down.
Fan-assisted cooking has been
selected and the food looks burnt.
Positions 1 and 5: the direct
heat could cause
temperature-sensitive
foods to burn.
We recommend switching
dripping pan positions halfway
through cooking.
The “Clock button” and the
digits on the display flash.
