5
GB
To open door
Option Buttons and Lights
On/Off Button & Light
Display Panel
Child Lock
Button & Light
Start/Pause Button &
Light
Clean
Condenser
Light
Programme
Progress Light
Programme Knob
Empty Water
Clean Filter
Light
Dryer Description
Control Panel
Indicator
The
On/Off
button/ light , if the dryer is running and this
button is pressed the dryer is turned off. The light signals
that your dryer is in use or ready to select a programme.
The
Programmes
knob sets the programme: rotate until
the indicator is pointing to the programme you want to
select
(see Start and Programmes).
The
Option
buttons/ lights select available options for your
selected programme. The lights indicate that the option
has been selected
(see Start and Programmes).
The
Display Panel
has three sections: Sensor Dry = Drying
level, Timed dry = Drying time and Time to End / Delay start
each with a corresponding selection button
(see The Display).
START/PAUSE
button with indicator light : when the
green indicator light flashes slowly, press the button to
start the programme. When the cycle has started, the
indicator light is illuminated in a fixed manner. To pause the
programme, press the button again; the indicator light will
turn orange and begin to flash again.
To restart the programme from the point at which it was
interrupted, press the button again
(see Start and
Programmes).
The Programme Progress Lights indicate each state of the
programme by turning on as appropriate.
(see Start and
Programmes).
The
Empty Water
indicator
H2O
signals that the water
container should be emptied. The light will take a few
seconds to go out after replacing the empty water
container; the dryer must be running for this to happen
(see
The Controls).
Note: if the water bottle is full the display shows
H2O
and the indicator flashes, the heat is turned off and your
clothes will not dry.
The
Empty Water Clean Filter
Light gives a reminder
before every programme, that its essential to clean the
filter and empty the water container every time the dryer is
used (see Maintenance and Care).
The
Clean Condenser
Light
gives a reminder, that its
essential to clean the condenser at regular intervals
(see
Maintenance and Care).
The
Child Lock
button/light
Press and hold this button
after selecting your programme and any options. This
prevents the programme settings from being changed.
When the light is lit the other buttons and programme knob
are disabled. Hold the button to cancel and the light will go
out.
ECO Light
- this light is illuminated as you select options
that use less energy (see the controls).
The Features
Pull on handle
Condenser unit
(cover open)
Water
container
Rating
Plate
Condenser
cover handle
(Pull to open)
Filter
Air Intake
Grille
Model &
Serial
Numbers
ECO Light
