30 of 33
Service Manual UK
Indesit
Company
English
I
Door Switch Assembly
1. Remove the restrainer securing the door seal to the front panel (R).
2. Remove the securing screw and working from the drum aperture behind the door seal, release the
remote rod and disconnect the wiring.
J
Belt & Pulley Removal
1. Remove the back panel (B).
2. Using pulley locking tool, Part No. C00560114 (560114) and Torx T40 bit Part No. C00222538
(5500048), remove the pulley fixing screw and ease pulley away from the shaft.
K Mains Suppressor
1. Remove the top cover (A).
2. Remove the screw securing the suppressor and mains cable unit to the cabinet.
3. Lift unit upwards and withdraw from cabinet.
Note: This unit is not a customer fit part.
L
Drum Assembly
1. Remove the top cover (A), back panel (B), door assembly (C), dispenser (F), suppressor (K), motor
(N), drum pulley (J) and door seal (H).
2. Remove the top concrete weight (E).
3. Remove 2 screws securing pump to front panel.
4. Disconnect wiring attached to the outer drum via cable clips and earth wire to suppressor.
5. Unclip the dispenser outlet hose from the dispenser and remove door seal from front panel.
6. Insert slide Part No. C00222704 (5600155) inside the cabinet at the rear of the drum.
7. Using suitable protection lay appliance on its back.
8. Remove 2 x 10 mm nuts securing the shock absorbers to the base of the cabinet.
9. Remove the tank/pump hose.
10. Carefully slide the outer drum clear, protecting any wiring.
M Front Concrete Weight
1. Remove the drum assembly (L).
2. Remove the counterweight fixing springs, see Page 18.
N Motor
1. Remove the screws securing back panel (B).
Release the belt from the motor pulley.
2. Remove two bolts securing motor. The motor should be supported when removing the last bolt.
3. Carefully lift the motor clear.
O Pump
1. Remove the plinth.
2. Using suitable protection, tilt the machine backwards and support.
3. Remove the pump fixing screws and disconnect the hoses and wiring.
