20 of 33
Service Manual UK
Indesit
Company
English
PROGRAMMING (Using Smartcard Reader / Card)
If the Main Module has been replaced during a repair the board will require programming using the
following method.
DEMO MODE
Activate Demo mode by pressing:
'On-Off' + 'Start/Pause' + the last option button on the right simultaneously for approximately 10 - 15
seconds.
NOTE: -
The machine must be plugged in and switched on at the wall socket, but switched off.
The display will be dark.
De-activate Demo mode by pressing:
'On-Off' + 'Start/Pause' buttons simultaneously for approximately 4 seconds. At this point an audible
'beep' will be heard.
NOTE: -
The machine must be plugged in and switched on at the wall socket, but switched off.
The display will be dark.
After cancelling 'Demo Mode' it will be necessary to re-select the correct language you require...see
next page.
1.
Do NOT connect the machine to electrical supply.
2.
Insert the pre-programmed card into the Card
reader. Care must be taken at this point to ensure
the card is inserted correctly with the Chip on the
card facing the PCB of the Reader.
3.
Insert the Reader and Card into module connection
port - see photo.
4.
Connect the machine to the Electrical supply
, the
LEDs on the Smart Card Reader will light in this
sequence:
a)
Red ON: Good Communication between Smart Card
Reader and Card.
b)
Red OFF; Green Blinking: Download taking place.
c)
At end, Green ON ---> Download OK.
d)
At end, Red ON or RED Flashing ---> Download
NOT OK.
5. Programming Complete, disconnect the machine
from Electrical supply.
6. Remove the Smart Card Reader.
Smart Card Reader
and Smart Card in use
