Hotpoint Ariston VS S15 AAW, Operating Instructions Manual, Page: 22 / 45

22
it en
TROUBLESHOOTING
Problem Possible causes / solutions
The device won’t turn on
• Maybe the plug is not inserted, or maybe it is not in contact.
•
Check the fuse or the switch.
•
Check that the power electronic regulator is not set on Off.
•
Check if the LED is on.
The suction power is low.
• Clean ilters. Should this be necessary, please replace them.
•
Please make sure that the brush and the suction tubing are not
obstructed.
• Please clean the dust container and its ilters.
The vacuum emits a hissing
sound or it vibrates when in use.
•
One or more tools were not mounted correctly. Please check that
the ilters, the dust container and the brush were mounted accor
-
ding to the most updated instructions.
•
The dust container is still full. Please clean the dust container.
• Clean ilters. Should this be necessary, please replace them.
The device does not emit steam.
•
Check if there is water in the tank.
•
The steam temperature is not high enough. After turning on the
device, please wait 20 seconds until it heats up.
• For your safety, the steam is emitted only if the device is not in its
rest position. Try and move the device from its rest position.
The device leaves some water
traces on the loor.
•
Please check if the cloth is not excessively wet.
•
The steam temperature is not high enough. After turning on the
device, please wait 20 seconds until it heats up.
The loors are not really bright,
they are too streaked or stained
after the cleaning process.
•
The cloth could be too dirty. Turn off the device by disconnecting
the plug from the wall socket and replace the cloth.
• If you wash the cloth with powder detergent, the dust could remain
trapped in the cloth. Please wash the cloth with liquid detergents.
• If you have to clean a loor with persistent stains, please spread
a chemical detergent on the loor, and then wash with the device.
• After washing with a chemical detergent, there could be some
residues on the loor. Wash again the loor with the device.
The device is hard to move.
•
Make sure the cloth is correctly positioned.
• Please check if the cloth is not excessively dirty; should this be the
case, please replace it.