![Hotpoint Ariston FT 820.1 IX/HA Operating Instructions Manual Download Page 21](http://html1.mh-extra.com/html/hotpoint-ariston/ft-820-1-ix-ha/ft-820-1-ix-ha_operating-instructions-manual_2169657021.webp)
2
1
GB
S
w
it
ch
in
g
t
h
e
a
pp
lian
c
e
o
ff
D
isconnect your appliance from the electricity
supply before carrying out any wor
k
on it.
C
leanin
g
t
h
e
a
pp
lian
c
e
Never use steam cleaners or pressure cleaners on
the appliance.
The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soa
k
ed in lu
k
ewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly.
D
o not use abrasive
powders or corrosive substances.
The inside of the oven should ideally be cleaned
after each use, while it is still lu
k
ewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth.
D
o not use abrasive products.
The accessories can be washed li
k
e everyday
croc
k
ery, and are even dishwasher safe.
C
leanin
g
t
h
e
o
v
en
d
oo
r
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth.
D
o not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crac
k
. For more thorough cleaning purposes, the
oven door may be removed:
1. Open the oven door fully
(
see diagram
).
2. Lift up and turn the small
levers located on the two
hinges (
see diagram
).
3. Grip the door on the two
external sides and close it
approximately half way. Pull
the door towards you, lifting it
out of its slot (
see diagram
).
To replace the door, reverse
this sequence.
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth.
D
o not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crac
k
.
Ins
p
e
c
tin
g
t
h
e
seals
Chec
k
the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
After-sales Service Centre.
W
e recommend that the
oven is not used until the seals have been replaced.
R
e
p
la
c
in
g
t
h
e
li
gh
t
b
u
l
b
To replace the oven light bulb:
1. Remove the glass cover of the lamp-holder.
2. Remove the light bulb and replace it with a similar one:
W
attage 25
W
, cap E 14.
3. Replace the glass cover (
see diagram
).
C
are
an
d
m
aintenan
c
e