1
5
GB
C
en
t
ring
a
nd
f
i
x
ing
*
1. Position brac
k
ets
A
against oven support
B
.
2. Position tabs
C
against brac
k
ets
A
. If the
thic
k
ness of the cabinet side panel:
is 16 mm thic
k
: place the tab so that the
number 16 written on it is facing you;
is 18 mm thic
k
: place the tab so that the part
without any text is facing you;
is 20 mm thic
k
: do not fit the tab.
3. Fix the brac
k
ets and tabs onto the edge of the
cabinet side panel using screws
D.
4. Fix the oven to the cabinet using the screws and
plastic washers
E
.
E
l
e
c
tri
c
al
c
o
nne
c
tio
n
s
!
Ovens equipped with a three-pole power supply
cable are designed to operate with alternating
current at the voltage and frequency indicated on
the data plate located on the appliance (
see below
).
F
i
tt
ing
t
he
p
o
w
er
suppl
y
c
a
b
le
1. Open the terminal
board by inserting a
screwdriver into the
side tabs of the cover.
Use the screwdriver as
a lever by pushing it
down to open the cover
(
see diagram
).
2. Loosen the cable
clamp screw and
remove it, using a
screwdriver as a lever
(see figure).
3. Remove the wire
contact screws L-N-
, then fasten the wires
under the screw heads,
respecting the colour
code: Blue (N), Brown
(L) and Yellow-Green
Verde ( ).
C
o
nnec
t
ing
t
he
suppl
y
c
a
b
le
to
t
he
m
a
ins
Install a standardised plug corresponding to the
load indicated on the data plate (
see side
).
The appliance must be directly connected to the mains
using an omnipolar circuit-brea
k
er with a minimum
contact opening of 3 mm installed between the appliance
and the mains, suitable for the load indicated and
complying with current electrical regulations (the earthing
wire must not be interrupted by the circuit-brea
k
er). The
supply cable must not come into contact with surfaces
with temperatures higher than 50°C.
!
The installer must ensure that the correct electrical
connection has been made and that it is compliant
with safety regulations.
Before connecting to the power supply, ma
k
e sure that:
The appliance is earthed and the plug is compliant
with the law.
The soc
k
et can withstand the maximum power of
the appliance, which is indicated on the data plate
(
see below
).
The voltage must be in the range between the
values indicated on the data plate (
see below
).
The soc
k
et is compatible with the plug of the
appliance. If the soc
k
et is incompatible with the
plug, as
k
an authorised technician to replace it. Do
not use extension cords or multiple soc
k
ets.
!
Once the appliance has been installed, the power
supply cable and the electrical soc
k
et must be easily
accessible.
!
The cable must not be bent or compressed.
!
The cable must be chec
k
ed regularly and replaced
by authorised technicians only (
see Assistance
).
! The manufacturer declines any liability should
these safety measures not be observed.
* Only on certain models.
E
E
D
A
B
D
D
16
16
16
16
C
C
C
