Hotpoint Ariston CX65SP4 (X) R, Operating Instructions Manual

Page: 21 / 54

20
GB
Start-up and use
Using the hob
Lighting the burners
For each BURNER knob there is a complete ring showing
the strength of the flame for the relevant burner.
To light one of the burners on the hob:
1. Bring a flame or gas lighter close to the burner.
2. Press the BURNER knob and turn it in an
anticlockwise direction so that it is pointing to the
maximum flame setting
E
.
3. Adjust the intensity of the flame to the desired level by
turning the BURNER knob in an anticlockwise direction.
This may be the minimum setting
C
, the maximum setting
E
or any position in between the two.
If the appliance is fitted with an
electronic lighting device* (
see
figure), press the BURNER
knob and turn it in an
anticlockwise direction,
towards the minimum flame
setting, until the burner is lit.
The burner may be
extinguished when the knob is released. If this occurs,
repeat the operation, holding the knob down for a
longer period of time.
!
If the flame is accidentally extinguished, switch off
the burner and wait for at least 1 minute before
attempting to relight it.
If the appliance is equipped with a flame failure safety
device*, press and hold the BURNER knob for
approximately 2-3 seconds to keep the flame alight
and to activate the device.
To switch the burner off, turn the knob until it reaches
the stop position •.
Practical advice on using the burners
For the burners to work in the most efficient way
possible and to save on the amount of gas consumed,
it is recommended that only pans that have a lid and a
flat base are used. They should also be suited to the
size of the burner:
!
For models equipped with a reducer grid, the latter
must be used only for the auxiliary burner, when
pans with a diameter of less than 12 cm are used.
Setting the time*
1. Press the PROGRAMMER knob and turn it in a
clockwise direction to
set the correct time.
! The clock can only be
set if the oven is
connected to the
electricity mains. In the
event of a power
failure, the
PROGRAMMER will
stop: the correct time
will need to be reset once the power has been
restored.
Starting the oven*
1. Turn the PROGRAMMER knob in a clockwise
direction until the “
!
” symbol appears in the display
window.
2. Pull the PROGRAMMER knob and turn it in a
clockwise direction until the red pointer is aligned
with the current time. A click will indicate the end of
the programming phase.
3. Turn the PROGRAMMER knob in a clockwise
direction until the “
9
” symbol appears in the display
window.
4. Select the desired cooking mode using the
SELECTOR knob.
5. To switch the oven off, turn the SELECTOR knob
back to the "0" position.
Programming cooking*
Programming a cooking duration with immediate
start
1. Turn the PROGRAMMER knob in a clockwise
direction until the desired cooking duration appears
in the display window.
2. Select the desired cooking mode using the
SELECTOR knob. The oven switches on immediately
and remains in operation for the entire set cooking
duration.
3. When the selected time period has elapsed, a
buzzer will sound. To silence it, turn the
PROGRAMMER knob in a clockwise direction until
the “
!
” symbol appears in the display window.
4. Turn the SELECTOR knob to the "0" position.
*
Only available in certain models.
To identify the type of burner, please refer to the
diagrams contained in the “Burner and nozzle
specifications”.
B urner ø C oo kw are Diameter (cm)
F ast (R) 24 - 26
Semi Fast (S) 16 - 20
Auxiliary (A) 10 - 14
Triple Crown (TC) 24 - 26