background image

1

ELECTRIC WALL OVEN INSTALLATION INSTRUCTIONS

A

B

D

I

50

3

/

4

"

(128.9 cm)

C

H

F

G

2" (5.1

cm) Min.

1

1

/

2

"

(3.8 cm)

Min.

11

1

/

2

"*

(29.2 cm)

3" (7.6

cm) Max.

Spacer

** Door Open

(see note)

Electrical

Junction Box

4" X 4"

(10.2 cm x

10.2 cm)

opening to

route

armored

cable.

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

FOR YOUR SAFETY:  Do not store or use gasoline or other flammable vapors and liquids in

the vicinity of this or any other appliance.

The first step of your installation should be to measure your current cutout dimensions and compare them
to the cutout dimensions chart below. You may find little or no cabinet work will be necessary.

NOTE:

1. Base must be capable of supporting 400 pounds

(181.4 kg).

2. Make sure base is level and front of cabinet is

square. If the cabinet base is not level, the oven
glides will tend to slide out
when opening the door.

** NOTE:

 Allow at least 23¼" (59.1 cm) clearance

for door depth when it is open.

NOTE:

 Dimension

 G

 is critical to the proper

Figure 1

P/N 318201520 (0411) Rev. A

English – pages 1-6

Español – páginas 7-13
Français – pages 14-20

All dimensions are in inches (cm).

 Do not remove spacers on the side walls and/or on the back of the built-in oven. These spacers

center the oven in the space provided. The oven must be centered to prevent excess heat buildup that may result
in heat damage or fire.

PRODUCT DIMENSIONS

CUTOUT DIMENSIONS AND CABINET WIDTH

MODEL

30" (76.2 cm) Wall Oven

MODEL

30" (76.2 cm) Wall Oven

A

30 (76.2)

Min.    F   Max.

28

½

 (72.4)      29 (73.7)

B

52

1

/

8

 (132.4)

G (Min.)

24 (61)

C (Rear wrapper)

28

1

/

4

 (71.8)

Min.    H   Max

.

51 (129.5)   51

3

/

4

 (131.4)

D

24

1

/

2

 (62.2)

I

30 (76.2) Min

installation of the built-in oven.  If the
oven decorative moulding does not butt
against the cabinet, or if noise is heard
on convection models, verify dimension

G

 to assure it is according to the required

dimension.

* Suggested distance from floor is 11½"

(29.2 cm).
Minimum required distance is 4½"
(11.4 cm).

Printed in United States

Summary of Contents for E30EW85EPS - Icon 30" Professional Series Electric Double Oven






Reviews: