19 of 33
Indesit
Company
Service Manual UK
English
DISMANTLING INSTRUCTIONS
SAFETY NOTES
1.
ENSURE THAT THE MACHINE IS UNPLUGGED BEFORE DISMANTLING.
2.
BEWARE OF SHARP EDGES ON METAL PANELS AND PRESSED PARTS.
A. Top Cover
1.
Remove the 2 screws securing the top cover to the back panel.
2.
Slide the top cover back and lift clear of the retainers.
B. Side Panels
1.
Remove the top cover.
2.
Remove the 4 screws securing the side panel to the rear panel and 1 screw securing the side
panel to the water container at the front of the dryer.
3.
Pull the side panel backward to disengage from the lugs on the base panel.
C. Door Assembly
1.
Remove the Top Cover (A)
2.
Disconnect the lead to the Control Card. The connector is situated along the top front edge of
the right hand side panel. (Fig.1)
3.
While holding the Door, remove 4 Torx T20 screws (2 per hinge) securing the Door hinges to
the cabinet. (Fig.2)
4.
Carefully feed the loom from the Control Card through the Top Hinge access hole, while lifting
the door clear. (Fig.3).
5.
It is important the hinge gasket is correctly located and fitted.
The cable tie must be tight and located exactly as shown below. Do NOT cut off the tail.
Fig.1
Fig.2
Fig.3
Gasket
Connector
Cable Tie
The cable tie MUST be located in
front of this raised edge
