28
I. Startup
WARNING
All parts are factory-adjusted. Improper adjustments may adversely affect safety,
performance, component life, and warranty coverage.
NOTICE
• If the icemaker is turned off, wait for at least 3 minutes before restarting the
icemaker to prevent damage to the compressor.
• To prevent damage to the water pump seal, do not leave the control switch in the
"PUMP" position for extended periods when the water tank is empty.
• At startup, confirm that all internal and external connections are free of leaks.
Additional Notice for Remote Models
• The icemaker must have power for a minimum of 4 hours prior to startup to
prevent compressor damage.
1) Open the water supply line shut-off valve(s).
2) If not already removed, remove the front panel. See Fig. 15.
3) Move the mode switch on the control box to the "ICE" position, then move the control
switch to the "ON" position. Replace the front panel, then turn on the power supply, and
allow the icemaker to operate. Note: If the icemaker fails to start, see "II.J. Bin Control
Check and Setting."
Fig. 15
Front Panel
Icemaker
4) Allow the icemaker to operate for 10 min.
5) After 10 min., turn off the power supply, then remove the front panel.
6) Move the control switch to the "OFF" position, then remove the base cover and
disconnect the rear pump tubing connection to drain the water tank. See Fig. 16.
Icemaker
Base Cover
Disconnect This
End of Pump Tubing
to Drain Water Tank
Fig. 16
Control Switch
Mode Switch
Control Switch
Mode Switch
Water Tank