56
16) Move the control switch to the "WASH" position to rinse off the cleaning solution.
17) Replace the front panel in its correct position.
18) After 5 minutes, remove the front panel.
19) Move the control switch to the "OFF" position, then unplug the icemaker from the mains
socket.
20) Disconnect one end of the pump tubing to drain the water tank. After the water tank has
drained, reconnect the pump tubing.
21) Repeat steps 13 through 20 three more times to rinse thoroughly.
Note: If you do not sanitize the icemaker, go to step 10 in "2. Sanitizing Procedure."
2. Sanitizing Procedure - Following Cleaning Procedure
1) Dilute 1.5 fl. oz. (44 ml) of a 5.25% sodium hypochlorite solution (chlorine bleach) with
3 gal. (11 l) of warm water.
2) Remove the insulation panel.
3) Pour the sanitizing solution into the water tank.
4) Replace the insulation panel in its correct position.
5) Plug the icemaker back into the mains socket, then move the control switch to the
"WASH" position to start the sanitizing process.
6) Replace the front panel in its correct position.
7) After 15 minutes, remove the front panel. Move the control switch to the "OFF" position,
then unplug the icemaker from the mains socket.
8) Disconnect one end of the pump tubing to drain the water tank. After the water tank has
drained, reconnect the pump tubing.
9) Repeat steps 13 through 20 in "1. Cleaning Procedure" two times to rinse thoroughly.
10) Replace the base cover in its correct position.
11) Clean the storage bin using a neutral cleaner. Rinse thoroughly after cleaning.
12) Plug the icemaker back into the mains socket, then move the control switch to the "ICE"
position to start the automatic icemaking process.
13) Replace the front cover in its correct position.
