23
7) Replace FS in its correct position and secure it with the two screws. Then connect FS
connector.
8) Replace the right side panel, rear panel and top panel in their correct positions.
9) Plug in the appliance, then move the control switch to the “ICE” position.
Legend:
CB
–control board;
FS
-float switch
F. Thermistor Check
A thermistor (semiconductor) is used as a harvest control sensor and anti-slush sensor.
The resistance varies depending on the suction line temperatures. The thermistor
detects the temperature of the evaporator outlet to start the harvest timer or momentarily
stop the pump motor during the freeze cycle. No adjustment is required. If necessary,
check for resistance between thermistor leads, and visually check the thermistor
mounting, located on the suction line next to the evaporator outlet.
Temperature (°F) Temperature (°C)
Resistance (kΩ)
0
-18
14.401
10
-12
10.613
32
0
6.000
50
10
3.871
70
21
2.474
90
32
1.633
Check a thermistor for resistance by using the following procedure:
1) Remove the louver. Move the control switch to the “OFF” position, then unplug the
appliance.
2) Disconnect the connector K1 on the board.
3) Remove the thermistor.
4) Immerse the thermistor sensor portion in a glass containing ice and water for 2 or 3
minutes.
5) Check for resistance between the thermistor leads. Normal reading is within 4.7 to 6.2
kΩ. Replace the thermistor if it exceeds the normal reading.
Summary of Contents for KM-300BAJ
Page 57: ...56 C Wiring Diagram ...