ENGLISH
5
Normal condition
or when food temp. For more intensive
is too low
cooling
7. The maximum safe height for displaying food
products is 9 cm above the interior bottom.
Food products should not be placed above
this height as they may not remain cold
enough to avoid spoilage.
8. If the showcase is turned off, wait for at least
3 minutes before restarting the showcase.
Otherwise the thermal motor protector may
operate and allow defrost water to drip onto
the items inside. The thermal motor protector
will reset automatically in 30 minutes.
9. To prevent damage to the
glass parts, do not place or
hit any tableware, bottles or
edged tools directly on the
glass surfaces. Even a tiny
flaw may grow into a crack (a
few days) later.
10. To avoid entrance of vermin
during operation, the two
drain outlets, on the right and
left under the food mounts
must always have the drain
plugs fitted.
1) Clean inside the showcase.
2) Plug in the showcase, and turn on the circuit
breaker.
* When not in use, dry the showcase thoroughly and
store it in a dry place.
III. MAINTENANCE AND CLEANING
INSTRUCTIONS
IMPORTANT
1. Before carrying out any cleaning or
maintenance operations, unplug the
showcase.
2. Do not disassemble the showcase further
than illustrated in Fig. 1.
3. D o n o t t o u c h o r w e t t h e m a c h i n e
compartment parts. This could result in
failure or breakdown.
4. To prevent possible damage, do not clean
the plastic parts with water above 40°C or in
a dishwasher.
1. INTERIOR/EXTERIOR
* Clean the interior and food mounts every day for
sanitary use.
* Clean off the exterior with a soft cloth soaked in
warm water containing a neutral cleaner and wrung
dry. Do not use a water jet to clean the exterior.
* Use only a neutral cleaner. Other chemical agents
might cause damage to the interior and exterior
surfaces.
Note: To prevent damage to the part surfaces and
the coating on the evaporator, do not use a
scourer on the interior/exterior surfaces.
2. DRAIN PIPE CLEANING
1) Either mix 1 liter of water with 3.7 ml of 5.25%
sodium hypochlorite solution in a suitable
container, or the recommended Hoshizaki
sanitizer as directed.
2) Disconnect the hose from the joint.
3) Turn up the end of the two joints .
4) Slowly pour the sanitizing solution into the drain
water circuit from the joints.
5) Wait for 5 minutes, and turn down the end of the
joints to drain the solution.
6) Leave the drain water circuit to dry out.
3. AIR FILTER
A plastic mesh air filter removes dirt or dust from the
air, and keeps the condenser from getting clogged. If
the filter gets clogged, the showcase's performance
will be reduced. Check the filter at least twice a
month. When clogged, use warm water and a neutral
cleaner to wash the filter.
1) Hold the tabs located at the bottom of the louver,
and lift them up to release the louver from the
body.
2) Pull the louver toward you.
3) Pull out the louver downward.
