ENGLISH
6
6. START-UP PROCEDURE
1) C h e c k t h a t t h e p o w e r s u p p l y c o r d i s
disconnected.
2) Move the operation switch on the operation
panel to the “ON” position.
3) Open the water supply tap.
4) Connect the power supply and energise.
5) The display will illuminate in the “ICE” mode.
6) The following should occur in sequence:
a) Water reservoir will fill.
b) Gear motor will start.
c) Compressor will start.
Water Supply Inlet G3/4
Drain Outlet R3/4
Inlet Hose
Outlet Hose
Water Supply Tap
Inlet Hose
Fig. 11
Fig. 12
Operation Panel
Ice Button Display Stop Button
Maintenance Button
(service use only)
Operation Switch
IMPORTANT
1. Check the conditions and quality of the ice
production.
2. Do not use ice produced in the trial run. It
might be contaminated with foreign matter
in the water circuit. Discard or flush down
the drain.
3. Clean the storage bin before use (see “III.
1. CLEANING” in instruction manual).
7. FINAL CHECKS
1) Is installation free of water leaks?
2) Is the icemaker free from vibration?
3) Are all the panels fixed and secure?
4) Has the user been instructed on correct machine
use and handed the instruction manual?
