6
If the foundation is not firm enough, it may
warp and cause some space between
its center and the showcase bottom. In
this case, provide a support to keep the
foundation level.
* Avoid a site where dripping is not allowed.
* Do not expose the showcase to direct sunlight or higher temperatures to prevent
damage to the plastic housing. Adding additional heat will also affect showcase operating
temperatures. Assure that there is no heat producing equipment located near the case,
no heating vents blowing on the case, or high wattage lamps shining on the case.
* Allow at least 6” (15cm) clearance between the condenser air inlet/outlet and the wall or
other equipment for proper air circulation. The rear of the showcase should have enough
space for smooth operation of the power switch and for easy access to the louver and air
fi
lter. Open space is required at the top of the showcase.
C. Setup
WARNING
Carry the showcase by holding its bottom.
AVERTISSEMENT
Portez la vitrine en la tenant par le fond.
Fig. 3
Support
No good
Good
Fig. 4
Air Inlet
Air Outlet
6”
6”
Open Space
