35
13) Position and lock the ice chute onto the front and rear frame pipes by pushing the ice
chute down until it clicks onto both frame pipes. See Fig. 45.
14) Slide in the water tank along the rails at the bottom of the left and right brackets until it
locks into place. See Fig. 46.
Right Bracket
Rail
Rail
Fig. 45
Fig. 46
Left Bracket
Ice Chute
Front Frame
Pipe
Rear Frame
Pipe
Water Tank
15) Reconnect the suction tube.
16) Hook each separator onto the rail, then pull it hard towards you until it locks into place.
See Fig. 47.
17) Replace the slope in its correct position. See Fig. 48.
Fig. 47
Fig. 48
Separator
Rail
Slope
18) Discard the sanitizing solution.
19) Mix a new batch of the sanitizing solution and slowly pour it into the water tank.
20) Move the control switch to the "WASH" position.
21) After circulating the sanitizing solution for 15 minutes, move the control switch to the
"OFF" position.
22) Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction
tube.
23) Repeat steps 19 through 22 one time.
24) Move the control switch to the "ICE" position and allow the icemaker to operate for
2 minutes. This allows the water tank to fill with water.
25) Move the control switch to the "WASH" position.
26) Allow the water to circulate for 5 minutes, then move the control switch to the "OFF"
position.
27) Disconnect the suction tube. Allow the water tank to drain, then reconnect the suction
tube.
28) Repeat steps 24 through 27 two more times to rinse thoroughly.
