PowerDisc coulter | 7
60029922 • 1 • 09/2020 • en
41
1. Loosen and remove the screw (A).
2. Loosen the screw (B), if necessary, but do not remove it.
3. Position the press roller and insert the screw (A) into the respective hole.
4. Fasten all screws again; the tightening torque is 100 Nm each.
NOTE
Ø
Set the press roller to the upper position for deep seed placement. This aligns
the coulter horizontally.
7.2.8 Rubber mounting
NOTE
Ø
Keep the rubber mounting free of oil.
Oils and grease can harm the rubber and thus adversely affect the function.
7.2.9 Harrow
The height and angle of attack of the harrow can be adjusted, if necessary.
1
Ø
Adjust the height: Unscrew the screw (1) and tighten the bracket again in the
next position.
2
