12/3/2019 | MAN1131-06-EN
Indianapolis, USA | Cork, Ireland | Calgary, Canada | Bangalore, India | Oakleigh, Australia | Tianjin, China | Esteio, Brazil
Please visit our website for a complete listing and to learn more about certified Horner Automation products.
This document is the property of Horner Automation Group, and is subject to change.
2.1 - Port Connectors
page 3 of 6
8
5
2
3
6
9
4
7
1
wiring: I-O continued on next page...
DC Input / Frame
DC Input / Frame
Solid/Stranded Wire:
12-24 awg (2.5-0.2mm).
Strip Length:
0.28” (7mm).
Torque Rating:
4.5 – 7 in-lbs (0.50 – 0.78 Nm).
DC- is internally connected to I/O 0V.
A Class 2 power supply must be used to meet UL requirements.
2.2 - Power Wiring
Primary Power Port Pins
PIN
SIGNAL
DESCRIPTION
1
Ground
Frame Ground
2
DC-
Power Supply Common
3
DC+
Power Supply Voltage
2 CONTROLLER OVERVIEW
3 WIRING: INPUTS AND OUTPUTS
Positive Logic vs. Negative Logic Wiring
The OCS can be wired for positive logic inputs or negative.
0V
I1
0V
I1
12-24VDC
Positive Logic In
Negative Logic In
3.1 - Digital Inputs
Digital inputs may be wired in either a Positive Logic or Negative Logic
fashion as shown. The setting in the Cscape Hardware Configuration for
the Digital Inputs must match the wiring used in order for the correct
input states to be registered.
Removing and Inserting Connectors:
Use a small screwdriver to gently pry up the connector. Gently press on
connector to snap into place.
Wiring Details:
Solid/Stranded Wire: 12-24 awg (2.5-0.2mm).
Strip Length: 0.28” (7mm)
Torque Rating: 4.5 – 7 in-lbs (0.50 – 0.78 Nm).
3.2 - Relay Life
WARNING:
Exposure to some chemicals may degrade the sealing proper-
ties of materials used in the Tyco relay PCJ.
Cover/Case & Base:
Mistubishi engineering Plastics Corp. 5010GN6-30
or 5010GN6-30 M8 (PBT)
Sealing Material:
Kishimoto 4616-50K (I part expoxy resin)
It is recommended to periodically inspect the relay for any degradation of
properties and replace if necessary.
Relay Life Expectancy
Contact Current (A)
4
Operation
(x10⁴)
40
30
20
10
0
1
2
3
1. Function Keys
2. High Capacity microSD Slot
3. RS232/RS485 Serial Connector
4. CAN Port (via RJ45)
5. USB Mini-B Port
6. Analog I/O
7. DC Inputs
8. DC Outputs
9. DC Power
NOTE:
See Precaution #12 on page 6 about USB and grounding.
Data Values
INPUT MODE:
DATA FORMAT, 12-bit INT:
0-20mA, 4-20mA
0-32000
Raw input values are found in the registers as Integer-type data with a
range from 0 – 32000.
Analog inputs may be filtered digitally with the Filter Constant found in
the Cscape Hardware Configuration for Analog Inputs. Valid filter values
are 0 – 7 and act according to the following chart.
3.3 - Analog Inputs Information
