PAGE 13 01 SEPTEMBER 1998 CHAPTER 2: INSTALLATIONS
HE500OCS050/051 User Manual
2.2
Mounting Requirements
The OCS is designed for permanent panel mounting. To install the OCS follow the instructions below:
1.
Cut the host panel as described in the corresponding drawing on the next page.
2.
Remove the rear cover by removing the four screws holding it in place.
3.
Insert the OCS through the panel cutout (from the front). The gasket material should lie between
the host panel and the OCS panel.
4.
Install four hex nuts on the four mounting studs of the OCS. Tighten these nuts until the gasket
material forms a tight seal. Do not over-tighten.
5.
Replace the rear cover screws, which secure it to the OCS.
6.
Connect the communications and power cables to the OCS ports.
Figure 2.13 – Panel Cutout for HE500OCS050/051
Note: Drawing is not to scale.
