LMAN0070-01-EN
Hazardous Location Series
07/29/20
Page 1
ETG-HLB
HazLoc Low Bay User Manual
GENERAL SAFETY INFORMATION
• To reduce the risk of death, personal injury or property damage from fire,
electric shock, falling parts, cuts/abrasions and other hazards, please read
all warnings and instruc�ons included with and on the fixture box and all
fixture labels.
• Before installing, servicing, or performing rou�ne maintenance upon this
equipment, please follow these general precau�ons.
• Commercial installa�on, service and maintenance of luminaires should be
performed by a qualified electrician.
•
DO NOT INSTALL DAMAGED PRODUCT!
• This fixture is intended to be connected to a properly installed and
grounded UL listed junc�on box.
• Make sure that the supply voltage is the same as the luminaire voltage.
• DO NOT install where the marked opera�ng temperatures exceed the
igni�on temperatures of the hazardous atmosphere.
• DO NOT operate in ambient temperatures above those indicated on the luminaire nameplate.
• All gasket seals must be clean and undamaged.
WARNING
RISK OF ELECTRICAL SHOCK
• Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
• Turn off the power when you perform any maintenance.
• Verify that supply voltage is correct by comparing it with the luminaire label informa�on.
• Make all electrical and grounded connec�ons in accordance with the Na�onal Electrical Code and
any applicable local code requirements.
• All wiring connec�ons should be capped with UL approved wire connectors.
• Luminaire must be supplied by a wiring system with an equipment grounding conductor.
CAUTION
RISK OF INJURY
• Wear gloves and safety glasses at all �mes when removing luminaire
from carton, installing, servicing or performing maintenance.
• Avoid direct eye exposure to the light source while it is on.
• Account for small parts and destroy packing material, as these may
be hazardous to children.
CAUTION
RISK OF FIRE
• Keep combus�ble and other materials that can burn away from
luminaire and lamp/lens.
• MIN 90ºC SUPPLY CONDUCTORS.
Image is for iillustra�on purposes only.
Your model may vary.
