background image

page 1

Protect  yourself. Before installing, read the entire instructions carefully and save them for future reference. 

Date installed:_____________

Failure to follow any of these instructions could void product warranties. For a complete list of product Terms and 

Conditions, visit www.acuitybrands.com. Acuity Brands Lighting, Inc. assumes no responsibilities for claims arising out of 

improper or careless installation or handling of its products.

INSTALLATION INSTRUCTIONS

UOLF_Rev 8/17/15

If further technical assistance is required, contact:  Technical Support at: (800) 748-5070.

LED Security Floodlight

Model Number(s): 

OLF 2RH 40K 120

OLF 2RH 40K 120 PE*

* PE denotes photocell option

   Suitable for wall mount or eave mount.                                     

          Not suitable for ground mount installation.

Mounting Hardware Included 

Silicone Sealant Required

Model Number(s): 

OLF 2SH 40K 120 

OLF 2SH 40K 120 PE*

Model Number(s): 

OLF 3RH 40K 120

OLF 3RH 40K 120 PE*

Summary of Contents for OLF 2SH 40K 120

Page 1: ... for claims arising out of improper or careless installation or handling of its products INSTALLATION INSTRUCTIONS UOLF_Rev 8 17 15 If further technical assistance is required contact Technical Support at 800 748 5070 LED Security Floodlight Model Number s OLF 2RH 40K 120 OLF 2RH 40K 120 PE PE denotes photocell option Suitable for wall mount or eave mount Not suitable for ground mount installation...

Page 2: ...urn away from lamp lens Do not operate in close proximity to persons combustible materials or substances affected by heat Never connect components under load jacket or damage wire insulation an LED product directly to a dimmer packs occupancy sensor timing directly off a switched circuit will prevent convection or cooling LED products are Polarity Sensitive Ensure proper Polarity before installati...

Page 3: ...it only use wire nut 6 to connect the copper Note If house wiring does not include a ground wire consult your local electrical code for approved grounding methods For proper connection place wire nut over wires and twist clockwise until tight 6 To Connect supply wires use wire nut 6 to connect the black wire to the white neutral supply wire insert mounting screw 3 into center hole of with rubber p...

Page 4: ...not come on or stays on Close Photocontrol cover Light should come on Photocontrol Light should go off light sources enters the photocontol To correct problem eliminate If Photocontrol cover is in closed position it will allow continuous If further technical assistance is required contact Technical Support at 800 748 5070 This LED light provides low maintenance service with no bulbs to change Clea...

Reviews: