Hornell Adflo, Instruction Manual

Page: 15 / 20

93-0061-00 Rev. A
15
Adflo ® Turbo Unit
If an OV/SD/CL/HC Adflo ® cartridge is already
installed, remove it as follows: hold the Adflo ® unit so
the “Adflo ® ” logo faces you; press in on the
OV/SD/CL/HC Adflo ® cartridge’s black catch on its
right side, and lift it out of the Adflo ® unit. The
OV/SD/CL/HC Adflo ® cartridge CANNOT be cleaned.
Dispose of the used cartridge as per local and federal
regulations.
To install a new OV/SD/CL/HC Adflo ® cartridge, hold
the Adflo ® unit so the “Adflo ® ” logo faces you; hook
the left side of the new OV/SD/CL/HC Adflo ®
cartridge into the left end of the Adflo ® unit; press the
cartridge down on its right side until its catch fully
engages (see Figure 17).
Next, inspect the Adflo ® Turbo Filter Cover and its
components. Replace as needed the HE filter, the
prefilter and the spark arrestor (see Section 3.3 for
complete instructions).
To reinstall the Adflo ® Turbo Filter Cover, hold the
Adflo ® unit so the “Adflo ® ” logo faces you. Then hook
the left side of the Adflo ® Turbo Filter Cover into the
left side of the OV/SD/CL/HC Adflo ® cartridge (see
Figure 18). Press down on the right side of the Adflo ®
Turbo Filter Cover until the catch fully engages.
Figure 17:
Installing the OV/SD/CL/HC Cartridge into the Adflo unit.
Figure 18: Installing the Adflo Turbo Filter Cover
onto the OV/SD/CL/HC Cartridge.
3.5 Replacing the Belt
Remove the old belt from the Adflo ® Turbo Unit by
unfastening the belt’s two Velcro ® straps and pulling
the Adflo ® unit away from the unfastened belt.
To attach the Adflo ® unit to the belt, first arrange the
belt so its two ends are higher than its middle; the belt
will look like a smile. Next, thread each Velcro
® strip
through the slot on the back of the Adflo ® unit, and then
on through the slot on the leather belt (see Figure 19).
Tightly pull the two Velcro ® strips prior to fastening
them to one another. When attached properly, the
Adflo
® unit is tight against the belt: it will not slide
around. When worn by the user, the buckle will be on
the left side and the belt’s tongue will be on the right
side.
Figure 19:
Adflo
® Belt Installation.
Figure 20:
Adflo
® Unit Installed on Belt