Hornbach JWS1100X, Manual

Page: 105 / 108

EN 105
INSTALL WHEEL
THICKNESS: < 4 MM
Install straight grinding wheels with the
lock nut 4 so that the flange points away
from the machine.
Press and hold the spindle lock button 2
and tighten the lock nut 4 with the wrench.
1
Remove the 3 screws from the guard lock
latch 3 , by use of a 3 mm allen wrench.
2 CHANGE GUARD
Remove the cutting wheel and the lower
flange 10 .
1
Rotate the grinding guard 9 into the de-
sired position. Make sure that the guard
lock latch 3 is engaged.
2
THICKNESS: ≥ 4 MM
Install depressed grinding wheels with
the lock nut 4 so that the flange points
towards the machine.
Press and hold the spindle lock button 2
and tighten the lock nut 4 with the wrench.
2
Install the cutting guard (accessory) by
use of the guard lock latch 3 and the three
screws.
Reinstall the lower flange 10 and install a
cutting wheel.
4
Remove the grinding guard 9 from the
tool.
3
Warning! Make sure the tool is
switched off and unplugged.
Warning! Make sure the tool is
switched off and unplugged.
Warning! The guard shall be oriented
to protect the auxiliary handle.
ADJUST GUARD
Pull up the grinding guard 9 at it’s very
end until it disengages from the guard
lock latch 3 .
1