I.
lV.
V.
Ill.
D
A
1.
Il.
2.
1.
1.
2.
3.
4.
3.
r 30mm
a 60°
B
C
max. 5 m
120 °
bb
aa
1
2
3
4
36
ENGLISH
GB
36
I.
Description
1
Remote control
2
LED power supply
3
Infrared sensor
4
RGB LED light strip
Caution:
Do not attach the light strip over sharp edges. Make sure that the
underground is flat or has a radius ≥ 30 mm/ angle ≥ 60 °.
1.
Cut the light strip
4
at the cutting mark to the desired length. Make sure that
the distance between power supply cord
2
and wall socket is covered.
2.
Clean all surfaces before applying the self-adhesive light strip. Remove the
protective backing of the light strip
4
.
3.
Affix the light strip
4
at the desired location by pressing it lightly with the fin-
gers onto the surface.
4.
Plug the power supply cord
2
into a suitable wall socket.
Caution:
Fully unwind the light strip from the cable reel before plugging in
the power supply cord.
II.
Assembly
Technical data
Nominal voltage
220-240 V~,
50/60 Hz
Rated power:
20 W
Protection class:
II/
Degree of protection: IP20
Colour temperature: Multi-color/ RGB
Light Source:
LED – non-
replaceable!
Weight:
250 g
Size (LxWxH):
5000 x 10 x 3 mm
ENGLISH
37
GB
37
Cleaning
1.
Disconnect the power cord
2
from the power outlet.
2.
Wipe the luminaire
4
with a soft, dry cloth only. Never use scouring powders
or chemical cleaning agents. Never allow the electrical components to
become damp.
Press buttons to regulate:
A:
Dimming/ Speed changing
B:
Colour control
C:
Colour mode/ light functions
D:
On/ off switch
Make sure to stay within the range of the infrared sensor
3
.
Keep infrared sensor on the light strip uncovered and free of
obstacles for proper functioning.
III.
Remote control
V.
Maintenance and care
1.
To change the battery, push the latch and pull out the battery compartment
of the remote control
1
.
2.
Observe the correct polarity and replace the battery by the same type of
battery (Type CR2025).
3.
Replace the battery compartment.
IV.
Battery change
