Horizon Hobby Vibe 500e, Assembly Instructions Manual

Page: 17 / 76

17
3-5 AttAchIng the mAIn drIve geAr - front Pulley
Soft
(×
2)
Socket Head Bolt, M2.6×15
………×2
Nylon Lock Nut, M2.6
…………………×2
…………………×2
Setscrew, M3×3
Main Shaft Spacer
…………………×1
Main Shaft
Main Shaft Collar
Front Pulley
Main Drive Gear
Assembly
Autorotation Collar
Nylon Lock Nut, M2.6 (2 Pcs)
Main Shaft Spacer
Note: After installing the Front
Pulley and Auto Rotation Assembly,
push down on the Main Shaft, and
pull up on the Main Shaft Collar
until it is against the top Main
Shaft Bearing Block. Tighten the
M3 x 3 Setscrews in the Collar
while holding the Main Shaft Collar
against the Bearing Block and the
Main Shaft pressed down against
the lower Main Shaft Bearing Block.
Note: The proper
direction to install the
Auto Rotation Collar is
as shown.
Note: If the Tail Boom is stuck and
cannot easily be moved, loosen the Gyro
Mount attachment screws.
Check that the Tail Drive Belt
direction rotation is correct as shown
and there are no twists in the belt.
Ensure the Tail Blades rotate in the
proper direction prior to flight.
Note: After the direction of the Tail Drive Belt has been confirmed, set the belt
tension. The belt tension should be set by pulling out on the Tail Boom so that
the belt will remain in contact with the Guide Roller when pressed with a finger
between the Front Pulley and Guide Roller. When the belt tension is set properly,
tighten the bolts left loose previously in step 3-3.
Note: After installing the Main Shaft
through the bottom Main Shaft Bearing
Block, install the M2.6 x 15 socket head
bolts through the Front Pulley and
Main Shaft and then through the Auto
Rotation Assembly and Auto Rotation
Collar by aligning the holes in each
assembly with the corresponding holes
in the Main Shaft.
Note: Install the Main Shaft in the proper
direction as shown through the top bearing
block, then through the Main Shaft Collar,
Front Pulley, Main Drive Gear Assembly,
Auto Rotation Collar, Main Shaft Spacer, and
finally the bottom Main Shaft Bearing Block.
Be sure to loop the Tail Drive Belt around
the Front Pulley in the direction shown
previously in step 2-9.