10
1-8
AttAchIng the lAndIng geAr
2-1
AttAchIng the tAIl Pulley cAse
Socket Head Bolt, M2.6×12
………×4
Flat Washer, M2.6
…………………×4
Soft
(×4)
Socket Head Bolt, M2×5
……………×2
Socket Head Bolt, M2.6×6
……………×1
Red
(×2
)
Red
0.5mm
Socket Head Bolt, M2.6 x 12 (4 Pcs)
Socket Head Bolt,
M2.6 x 6
Socket Head Bolt, M2 x 5 (2 Pcs)
Tail Pitch Control Base
Clear Tape
Tail Pulley Case
Tail Pulley
Tail Drive Belt
Tail Boom L470
Flat Washer, M2.6 (4 Pcs)
Landing Gear
Note: After the
landing gear is
installed, fully
tighten the bolts
left loose from
Step 1-5.
Note: To easily pull the tail drive
belt through the tail boom, wrap a
small piece of tape around the belt
using great care to not pinch the
belt at the bend and weakening
the belt. Caution: If the belt is bent
or kinked during assembly it will
damage the belt and cause a failure
resulting in loss of tail control.
Note: Tighten the M2.6 x 6 socket
head bolt carefully when tightening
on the Tail Boom, the Tail Boom will
be damaged if overtightened. There
should be a gap remaining in the
clamp when fully tightened.
Note: The notched end of the tail boom
installs into the Tail Pulley Case. Insert the
Tail Boom as deeply as possible.
Summary of Contents for Vibe 500e
Page 47: ...47 6 1 Installing the Speed Controller 6 2 Installing the Receiver and Gyro 2 2 2 2...
Page 48: ...48 6 3 Fixing the Wiring 6 4 Installing the Battery 2 2 6S Li Po Battery Not Included...
Page 49: ...49 6 5 InstAllIng the body 2 2 Body Rubber Grommet 3 Pcs...