CCPM SOFTWARE ACTIVATION AND INITIAL ADJUSTMENT (CONTINUED)
4. JR X-378 SYSTEMS
23
The following activation and setup procedures should be used for all JR X-378 systems.
Prior to activating the CCPM function, it is first suggested that the Data Reset function be performed to reset the desired model number to be used
back to the factory default settings. If you are using a new radio system, proceed to Step B.
Caution: Prior to performing the Data Reset function, it will be necessary to select the desired model number to be used.
A)
Press the Down and Channel keys simultaneously while turning the power switch on to enter the system mode. Next, press the Up key until the word
“Model” flashes on the top right portion of the screen. Press the (+) or (-) keys to select the desired model number to be used. Press the Up key until
“RESET” appears on the screen. Next, press the Clear key to reset the data for this model. A “beep” will be heard and the letters “CL” will flash when the
Clear key is pressed, indicating that the data has been reset successfully.
B)
Press the Up key until the word “SWASH” appears on the left side of the screen. Next, press the (+) or (-) keys until the word “3SERV” appears on the
screen. This would indicate the selection of Three-Servo 120 Degree CCPM. Press the Down and Channel keys simultaneously to store this data and exit
the System mode.
C)
Press the Down and Channel keys simultaneously to enter the Function mode. Next, Press the Up or Down keys until the words “SWASH” and “3S120”
appear on the screen. Once at this screen, it will be necessary to change the values for each of the three CCPM channels as shown using the Channel
key to select the desired channel, and the (+) and (-) keys to alter the values.
D)
Press the Up or Down keys until the word “REV.” appears on the top left portion of the
screen. Next, reverse the rudder and aileron channels by using the Channel key to select the
desired channel and the (+) or (-) keys to change the servo direction from NORM to REV.
E)
Press the Up or Down keys until the word “TRAVL” appears on the top left portion of
the screen. Adjust the servo travel values as shown using the Channel key to select
the desired channel to be adjusted, and the (+) or (-) keys to increase or decrease the
travel value as needed. Please note that the required travel values can vary slightly
based on the type of servo selected. Please also note that the throttle travel values
may vary based on the type of engine used. This value can be fine tuned once the
throttle linkage has been installed.
Note: The travel values shown for the rudder function are for use with Piezo-type
gyros like the JR G410T and G460T.
Proceed to page 24.
Model Type
Model Number
Model Number
Data Reset
Indicates
Swashplate Type
Indicates 3-Servo CCPM
Indicates 120° CCPM
3SERV
120
AILE
+70
∞
ELEV
+70
∞
PIT.
-65
∞
RUDD
Rudder Channel
Direction
(normal or reverse)
Aileron Channel
Travel Adjust Function
Travel Value
Travel Values:
Throttle: 120/120
Aileron: 100/100
Elevator: 100/100
Rudder: 150/150
Gear: 100/100
Pitch: 100/100
Aux2: 100/100