EN
7
FAILSAFE
In the unlikely event that the radio link is lost during use, the receiver will drive
the throttle channel to the neutral position. If the receiver is powered on prior
to turning on the transmitter, the receiver will enter the failsafe mode, driving
the throttle channel to the neutral position. When the transmitter is turned on,
normal control is resumed.
IMPORTANT:
Failsafe activates only in the event that signal is lost from the
transmitter. Failsafe will NOT activate in the event that receiver battery power
decreases below the recommended minimums or power to the receiver is lost.
IMPORTANT:
You must rebind the transmitter and receiver if you:
• change the servo reversing after binding
• change the travel after binding
• change the receiver mounting orientation
• use the receiver with a different model memory
• install the receiver in a different vehicle
• use the receiver in 5.5ms and want telemetry, rebind in 11ms
• use the receiver with a DSMR transmitter and you change the frame rate
in the transmitter
DISABLING MS6X TECHNOLOGY
MS6X may be disabled during binding.
1.
Connect power to the receiver and quickly press and release the bind
button three times (within 1.5 seconds).
2.
Connect power to the receiver, power on, press and release the bind
button three times (within 1.5 seconds from the first push).
When the MS6X system has been disabled, the LED on the receiver will show
three flashes upon power up, and then remain lit. The receiver is bound and
operating normally when the LED remains illuminated.
TIP:
If the MS6X feature in the receiver is active and the MS6X menu in the
transmitter is Inhibited, MS6X functions will default to the AUX 1 and AUX 2
operation, and
in this scenario, MS6X will not work correctly.
Selecting INH in the MS6X menu on your transmitter will not disable
MS6X.
Summary of Contents for SPEKTRUM SMART SR6300PM
Page 19: ...EN 19...
