7
2. Connect the three motor wires from the ESC to the motor wires
in any order.
In the event the motor spins the wrong direction, reverse any two
wires.
3. Connect the throttle servo lead to the throttle port on your receiver.
4. Secure all wiring so it is protected from damage or being caught
by moving parts.
NOTICE:
Do not connect a dedicated receiver battery to the
receiver along with the ESC. When the ESC is turned On it will
provide the receiver with 6V regulated power from the main
battery through the throttle connection. The ESC may be damaged
if the receiver is also connected to a dedicated receiver battery.
ESC and Transmitter Calibration
1. Begin with the transmitter and receiver binding complete.
2. Set your transmitter’s throttle channel to 100% travel and
trim to neutral.
3. Turn on your transmitter and connect a battery to the ESC but
don’t power it on.
4. Press and hold the Set button while turning on the ESC.
When the red LED begins to flash, release the Set button.
The ESC will enter programming mode if the button is
pressed for more than three seconds.
TIP:
The red LED should be flashing when the ESC enters
calibration mode. If the green LED is flashing the ESC is in
programming mode.
