8
EN
BINDING
The radio system should be checked before operating the vehicle to ensure proper operation and adequate range.
1. Turn on the transmitter.
2. Connect the battery in the vehicle.
3. Have a friend hold the vehicle while keeping hands and loose clothing away from moving parts.
4. Walk away until you are at the maximum planned operating distance from the vehicle.
5. Turn the steering wheel side to side and operate the throttle, both forward and reverse, checking for any
erratic behavior.
6. If any erratic behavior is exhibited, DO NOT operate the vehicle. Call customer service for assistance.
RANGE-CHECKING THE RADIO SYSTEM
Bind Button
Bind Button
Power Button
Binding is the process of programming the receiver to recognize the
GUID (Globally Unique Identifier) code of a single specific transmitter.
The transmitter and receiver are bound at the factory. If you need to
rebind, follow the instructions below.
1. Connect a fully charged battery pack to the ESC/receiver.
2. Disconnect the two-speed transmission servo lead from the
receiver.
3. Push and hold the receiver bind button.
4. Power on the vehicle.
5. Release the bind button after the receiver goes into bind mode,
indicated by the flashing LED.
6. With the throttle trigger at neutral, press and hold the transmitter
bind button while powering on to put the transmitter in bind mode.
The throttle should be at neutral to set failsafe.
7. The bind process is complete when the LED on the receiver
remains lit.
8. Connect the two-speed transmission servo lead to the receiver.
You must rebind when different failsafe positions are needed e.g.,
when throttle or steering reversing has been changed.
The vehicle includes an installed two speed transmission, capable of
changing speeds with the A/B switch on the transmitter.
To operate the two speed transmission:
1. Slow the vehicle to approximately 1 mph.
2. Toggle the A/B switch on the transmitter to change gears.
NOTICE:
Do not attempt to change gears while the vehicle is
either not moving or moving at a high rate of speed. Damage to the
transmission gears or the transmission servo will result.
USING THE TWO SPEED TRANSMISSION
