Sonicwake
®
36 V2 Self-Righting Deep-V Brushless RTR
1.
Power off the ESC.
2.
Power off the transmitter.
3.
Disconnect and remove the battery from the boat.
TIP:
Always remove the canopy before storage or moisture
may allow mold and mildew to grow in the boat.
4.
Drain water from inside the hull using the drain plug.
5.
Fully dry the inside and outside of the boat, including the
water cooling lines and jacket around the motor. Carefully
dry all battery, motor and receiver connectors by removing
one at a time and reinstalling.
6.
Remove the hatch before storing your boat.
7.
Repair any damage or wear to the boat.
8.
Lubricate the flex shaft using Pro Boat® Marine Grease
(DYNE4200 or DYNE4201).
9.
Note the lessons learned from the trimming of your boat,
including water and wind conditions.
10.
Replace the rudder cover to protect the rudder’s sharp
points.
NOTICE:
When you are finished boating, never leave the
boat in direct sunlight or in a hot, enclosed area such as a
car. Doing so can damage the boat.
NOTICE:
Using a larger propeller, or one with more pitch
than the one included (on 6S [22.2v]), may damage the
electronics and battery packs.
When You Are Finished
Getting Started
1.
Power on the transmitter.
2.
Connect the two batteries to the IC5
®
connectors on the
ESC.
3.
Power on the ESC switch. The ESC arming tones will
sound.
4.
Test the transmitter’s control of the boat with the boat on
the display stand.
5.
Remove the rudder cover before operating the boat.
6
EN
1
ST/R
TH/R
50/75/1
00
TH/LIM
2
3
X2
ST/R
TH/R
50/75/1
00
TH/LIM
S/R
STATUS
TH
ST
B
A
X2
1
2
3
4
