![Horizon Hobby PRB08032V2 Owner'S Manual Download Page 4](http://html1.mh-extra.com/html/horizon-hobby/prb08032v2/prb08032v2_owners-manual_2163347004.webp)
Sonicwake
®
36 V2 Self-Righting Deep-V Brushless RTR
Transmitter Functions
Installing the Transmitter Batteries
CAUTION:
If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable
batteries may cause the batteries to burst, resulting in injury to
persons and/or damage to property.
This transmitter requires 4 AA batteries.
1.
Remove the battery cover from the transmitter.
2.
Install the batteries as shown.
3.
Install the battery cover.
CAUTION:
Risk of explosion if battery is replaced by an
incorrect type. Dispose of used batteries according to
national regulations.
CAUTION:
Never remove the transmitter batteries while
the model is powered ON. Loss of model control, dam-
age, or injury may occur.
A. Throttle Trim
Adjusts the throttle neutral point
B. Steering Trim
Adjusts the steering center point. Normally, the steering
trim is adjusted until the vehicle tracks straight.
C. LED
• Solid red lights:
Indicates the power is ON and
adequate battery power
• Flashing red lights:
Indicates the battery voltage is
critically low. Replace batteries
D. Steering Wheel
E. Throttle/Brake
F. Steering Rate
On-The-Fly knob for travel adjustment on the steering
G. Channel 3
3 position momentary switch, middle position is neutral
For programming press up for A button, press down for B
button
H. Throttle Limit
Limits throttle output to 50/75/100%
Select 50% or 75% for less experienced drivers or when
you are driving the vehicle in a small area.
I. Throttle (TH) Servo Reversing
Move the switch to reverse the throttle channel
J. Steering (ST) Servo Reversing
Move the switch to reverse the steering channel
K. Power Button
A
B
C
D
E
F
G
H
I
J
K
4
EN
Install the receiver antenna in the tube as shown. Do not bend
end of antenna over antenna tube and place cap over it. The
antenna does not have to be outside of the tube to operate
properly.
Keep the end of the antenna above the boat’s waterline to get
the best transmitter reception. Apply clear tape (DYNM0102),
if desired.
NOTICE:
Do not cut or kink the receiver antenna or damage
may result.
Antenna Tube Installation