EN
9
Center of Gravity (CG)
The CG location is measured from firewall forward. This CG location has been
determined with the recommended Li-Po battery (EFLB22003S300).
Control Direction Test
1. Place the aircraft into
a mode without SAFE
®
technology.
2. Face the aircraft away from you.
3. Move the sticks on the transmitter and ensure
the aircraft responds as shown.
AS3X Control Response Test (BNF only)
This test ensures that the AS3X
®
control system is functioning properly.
Assemble the aircraft and bind your transmitter to the receiver before
performing this test.
1. Raise the throttle just above 25%, then lower the throttle to
activate AS3X technology.
CAUTION:
Keep all body parts, hair and loose clothing away from a
moving propeller, as these items could become entangled.
2. Move the entire aircraft as shown and ensure the control surfaces move in
the direction indicated in the graphic. If the control surfaces do not respond
as shown, do not fly the aircraft. Refer to the receiver manual for more
information.
Once the AS3X system is active, control surfaces may move rapidly. This is
normal. AS3X remains active until the battery is disconnected.
Transmitter
Input
Control Surface Reaction
(viewed from the rear)
Elevator
forward
Elevator
back
Transmitter
Input
Control Surface Reaction
(viewed from the rear)
Aileron
right
Aileron
left
Aircraft
Movement
Control Surface Reaction
(viewed from the rear)
Pitch up
Pitch down
Roll left
Roll right
67mm
